5.0(137 REVIEWS)
  • Mon: 8:00 am-6:00 pm
  • Tue: 8:00 am-6:00 pm
  • Wed: 8:00 am-6:00 pm
  • Thu: 8:00 am-6:00 pm
  • Fri: 8:00 am-6:00 pm
  • Sat: Closed
  • Sun: Closed
2307 Foulk Rd Wilmington, DE 19810
Schedule Appointment
(302) 308-3183

Toyota

Home » Toyota

  • 2010 Toyota RAV4

    Toyota RAV4
    Mileage
    58,255
    Service Date
    12/31/2025
    Services Performed
    • JLS AUTOMOTIVE COURTESY INSPECTION
    • R + R BOTH FRONT LOWER CONTROL ARMS; REPLACE W/NEW, REASSEMBLE AND RECHECK
    • Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel.
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures.
     
    STACY C. gave our service a 5 star review on 12/31/2025

  • 2006 Toyota Corolla

    Toyota Corolla
    Mileage
    141,789
    Service Date
    5/30/2025
    Services Performed
    • JLS AUTOMOTIVE COURTESY INSPECTION
    • R + R SERPENTINE BELT TENSIONER, SERPENTINE BELT, AND IDLER PULLEY W/NEW UNITS AND RECHECK
    • BRAKE SHOES &/OR PADS – Remove & Replace – CE,LE,S Rear,Drum Brakes,Both Sides – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include ref
    • Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
    • R + R REAR STRUTS W/NEW COMPLETE UNITS AND RECHECK
    • Inspect hoses and clamps. Pressure test cooling system. Drain and refill coolant . Check thermostat and electric cooling fan operation.
    • 2 PART SERVICE INCLUDES: -BG Platinum® 44K® cleans the entire fuel system, including fuel injectors, fuel filters, and combustion chambers. Because it provides efficient removal of upper engine deposits, BG Platinum® 44K® reduces problems caused by deposit buildup such as engine surge, misfire, stumble, hesitation and power loss. BG Platinum® 44K® provides quick cleanup of coked fuel injectors and corrosive deposits on the Fuel Sending Unit. It restores power output, engine performance, reduces engine knock or run-on tendencies, improves combustion performance, removes accumulated deposits from oxygen sensors, and it’s effective in cleaning catalytic converters. -BG Air Intake & Valve Cleaner removes sticky, heavy deposits from the backs of valves and in air intake systems of gasoline direct injection (GDI) and port fuel injection (PFI) engines. Sprayed directly into the intake, BG Air Intake & Valve Cleaner restores fuel efficiency and engine performance, and reduces harmful exhaust emissions. (STANDARD DISCLAIMER: FUEL INDUCTION CHEMICAL IS A HEAVY CLEANER, IT IS NORMAL TO SEE SMOKE COMING FROM THE EXHAUST FOR 100 MILES OR SO, ALSO IT CAN POTENTIALLY RESULT IN THE CHECK ENGINE LIGHT ILLUMINATING AFTER SERVICE, THIS IS RARELY THE CASE, HOWEVER IF THIS HAPPENS, SIMPLY RETURN AND WE WILL CLEAR THE LIGHT, NO CAUSE FOR ALARM)
    • R + R SPARK PLUGS W/NEW
    • R + R WATER PUMP W/NEW UNIT
    • Thoroughly cleaned off all accumulated oil, grime, and other fluids from the exterior surface of the engine block to ensure a clean and visible area for inspection. This process involved using specialized cleaning agents and tools to break down and remove the built-up contaminants, allowing for a clear view of any potential leaks. After cleaning, UV dye was carefully added to the engine oil to help identify any future leaks more effectively. The dye will fluoresce under UV light, making it easier to locate any oil leaks during the follow-up inspection. The customer has been advised to return for a follow-up inspection in approximately 200 miles of driving, at which point the vehicle will be checked to confirm the location of any leaks. ***Fixed leak by installing hose clamp on power steering line***
     
    PAUL W. gave our service a 5 star review on 5/31/2025

  • 2007 Toyota Prius

    Toyota Prius
    Mileage
    260,457
    Service Date
    3/25/2025
    Services Performed
    • JLS AUTOMOTIVE COURTESY INSPECTION
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures.
    • BG EPR® Engine Performance Restoration® softens, emulsifies, and dissolves even the most stubborn fuel gums that clog piston rings. It cleans micro passageways to maintain the critical hydraulic function of components. It removes carbon deposits, restores compression, lowers tailpipe emissions, and reduces oil consumption by restoring ring function. BG Advanced Formula MOA® protects engine components and fortifies all brands of engine oil. It uses friction modifiers that enhance the fuel economy and fuel economy retention properties of engine oils. It controls the formation of sludge and varnish and retains performance throughout the service interval. BG Advanced Formula MOA® keeps piston rings from sticking, stabilizes oil viscosity, prevents increased exhaust emissions, reduces wear, prevents sludge and varnish, and is resistant to evaporative oil loss.
    • INSTALL AIR FILTER
    • R + R BOTH FRONT STRUT ASSEMBLIES; REPLACE W/NEW, REASSEMBLE AND RECHECK
    • R + R R/F INNER AND OUTER TIE ROD ENDS; REPLACE W/NEW, REASSEMBLE AND RECHECK
    • Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel.
    • R + R BOTH FRONT AXLE SHAFT ASSEMBLIES; REPLACE W/NEW, REASSEMBLE AND RECHECK
    • REMOVE WHEEL(S) FROM VEHICLE; REMOVE OLD TIRE(S) FROM RIM; INCLUDES REPLACEMENT OF VALVE STEM(S) AND/OR TPMS SERVICE KIT(S) AS NEEDED; CLEAN RIM(S) OF ANY CORROSION, APPLY BEAD SEALER AS NEEDED AND REMOVE OLD WHEEL WEIGHTS; INSTALL NEW TIRE(S) AND COMPUTER SPIN BALANCE; RE INSTALL ON VEHICLE AND TORQUE WHEELS TO APPROPRIATE SPECIFICATIONS.
    • Replace Front Brake Pad Linings and Front Brake Disc Rotors. Clean and lubricate Brake Calipers and Slide mechanisms. Check and fill brake fluid. Road test vehicle.
     
    ALBIE P. gave our service a 5 star review on 3/25/2025